In this tutorial, we will focus on FANUC CNC Integration with CNC gateway. We hope this proves helpful.
In the previous lessons, we covered :
Comment la mini-passerelle CNC EG8200 s'interface avec les systèmes CNC de Siemens
Comment intégrer le CNC Gateway avec la CNC Mitsubishi
Comment intégrer le CNC Gateway à la nouvelle génération de CNC ?
Comment intégrer la CNC Gateway à la CNC HAAS
Comment la passerelle CNC de la série EG s'interface avec la CNC Maritx
This lesson will provide a detailed explanation for FANUC CNC systems.
Compatible CNC: Fanuc Series 0iD/0iF/30i/31i/32i/35i
1. Connexion du matériel
The Fanuc CNC protocol uses Ethernet communication. Therefore, only ensure the gateway’s LAN port IP and the CNC’s IP are within the same subnet (Note: In special cases, they may be on different subnets, requiring routing configuration—consult technical support for details). IP addresses are assigned as follows in this example:
|
EG8200Passerelle mini-CNC |
FANUC CNC |
|
| Adresse IP |
192.168.110.88 |
192.168.110.108 |
2. Paramètres de communication de la CNC
Provided by CNC engineers.
The CNC network port parameters are:
IP : 192.168.110.108
Port : 8193
FANUC CNC IP Configuration Panel:
FANUC Port Configuration Interface:
3. Paramètres de la passerelle
3.1. CNC Connection Settings
Drag a Fanuc node from the CNC panel on the left. Double-click to open the settings page and configure as follows based on the PLC parameters:
Adresse : 192.168.8.16
Port : 8193
Délai de connexion : 5000
Heartbeat Interval: 60000
Data Timeout: 2000
Data Interval: 1000 (Read Cycle)
Cycle Wait: 1000 (Data Point Read Interval)
3.2. Data Point Settings
Check the required data points.
3.3. Essais
Click Deploy and observe a data point being printed every few seconds. Verify the received data points to confirm successful communication!
For the data point reference table, please refer to:
Il s'agit d'une carte de contenu Yueque. Cliquez sur le lien pour l'afficher : https://iotrouter.yuque.com/zn3vdn/eg8000/om7gm3hef68gt7fb
