This guide explains how to integrate Omron PLC with EG Edge Gateway using the FINs protocol for industrial automation and data collection. It is part of the Siemens PLC communication series.
Статья, о которой мы говорили ранее:
How to interface with Omron PLC via EtherNet/IP protocol
How to interface with Omron PLC via Hostlink protocol
1. Подключение оборудования
Compatible PLC: NJ101-1000
The FINS protocol uses Ethernet communication, so it is only necessary to ensure that the gateway’s LAN IP and the Omron PLC’s IP are on the same subnet (Note: in special cases, they do not need to be on the same subnet, but routing must be configured. For details, consult technical support). The IP addresses in this example are assigned as follows:
| EG8200Mini | Omron PLC | |
| IP address | 192.168.0.80 | 192.168.0.2 |
2. Параметры связи с ПЛК
2.1. Настройки параметров Ethernet
2.2. Variable Addresses
3. Настройки шлюза
3.1. Настройки подключения ПЛК
Drag an Omron node from the left panel and double-click to open the settings page. Configure it according to the PLC’s communication parameters as follows:
Протокол: Select FINS
Адрес: Enter the PLC address, in this example: 192.168.0.2
Порт: Enter the PLC connection port, in this example: 9600
Таймаут соединения: 2000
Таймаут связи: 2000
Mode: TCP
Unit Number: 0
Byte Order: ABCD
3.2. Конфигурация точки данных
In the parameter list of the Omron node, enter the data points you want to read. Once the data points are configured, the gateway will automatically read the PLC data at the set frequency.
Data points are usually provided by the PLC engineer. After receiving the point table, fill in the data points according to the format required by the gateway. For specific mappings, refer to:
Yuque content card:（Вы можете использовать Google Chrome для перевода）. https://iotrouter.yuque.com/zn3vdn/eg8000/skfapgdm7332it5q
In this example, data from addresses D100 and D102 are read. In the parameter list, fill in the Address / Name / Data Type / Data Length, and set the reading cycle to 2 seconds, as shown below:
3.3. Тестирование
Нажмите Развернуть and observe that a data entry is printed every 2 seconds. The read data points should appear as: D100: false, D102: 99. Communication is successful!
Связанные руководства по интеграции промышленных ПЛК
← Вернуться на страницу «Центр интеграции ПЛК»
Agnes Wang is an IoT Solutions Specialist at IOTRouter, focusing on industrial IoT gateways, edge computing, and industrial automation solutions.
She specializes in industrial communication technologies, including Modbus, IEC 60870-5-104, MQTT, OPC UA, PLC integration, and remote monitoring applications. She contributes to technical articles and application guides covering industrial IoT solutions, protocol conversion, and edge computing.
